TP-Link T2600G-28TS Reference Manual page 38

Mode Accessing Path
Layer 3 Interface:
Use the no
switchport command
to enter Routed Port
mode from Interface
Configuration mode.
Use the interface
vlan vlan-id command
Interface
to enter VLAN
Interface mode from
Configuration
Global Configuration
Mode
mode.
Use the interface
loopback id
command to enter
Loopback Interface
mode from Global
Configuration mode.
Use the vlan vlan-list
VLAN
command to enter this
Configuration
mode from Global
Mode
Configuration mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a Telnet/SSH connection.
2. Each command mode has its own set of specific commands. To configure some commands,
you should access the corresponding command mode firstly.
Global Configuration Mode: In this mode, global commands are provided, such as the

Spanning Tree, Schedule Mode and so on.
Interface Configuration Mode: In this mode, users can configure one or several ports,

different ports corresponds to different commands
a). Interface gigabitEthernet: Configure parameters for an Ethernet port, such as
Duplex-mode, flow control status.
b). Interface range gigabitEthernet: Configure parameters for several Ethernet ports.
c). Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm.
d). Interface range link-aggregation: Configure parameters for multi-trunks.
Prompt
T2600G-28TS (config-if)#
or
T2600G-28TS(config-if-range)#
T2600G-28TS (config-vlan)#
18
Logout or Access the next
mode
Use the switchport command to
switch to the Layer 2 interface
mode.
Use the end command or press
Ctrl+Z to return to Privileged
EXEC mode.
Enter the exit or the # command
to return to Global Configuration
mode.
Use the end command or press
Ctrl+Z to return to Privileged
EXEC mode.
Enter the exit command or the #
command to return to Global
configuration mode.