Preface - TP-Link TL-SG3210 Cli Reference Manual

Preface

This Guide is intended for network administrator to provide referenced information about CLI
(Command Line Interface).
TL-SG3210/TL-SG3216/TL-SG3424/TL-SG3424P without any explanation. The commands in this
guilde apply to these four models if not specially noted, and TL-SG3424 is taken as an example
model in the example commands.
Overview of this Guide
Chapter 1: Using the CLI
Provide information about how to use the CLI, CLI Command Modes, Security Levels and some
Conventions.
Chapter 2: User Interface
Provide information about the commands used to switch between five CLI Command Modes.
Chapter 3: IEEE 802.1Q VLAN Commands
Provide information about the commands used for configuring IEEE 802.1Q VLAN.
Chapter 4: MAC-Based VLAN Commands
Provide information about the commands used for configuring MAC-Based VLAN.
Chapter 5: Protocol-Based VLAN Commands
Provide information about the commands used for configuring Protocol-Based VLAN.
Chapter 6: Voice VLAN Commands
Provide information about the commands used for configuring Voice VLAN.
Chapter 7: GVRP Commands
Provide information about the commands used for configuring GVRP (GARP VLAN registration
protocol).
Chapter 8: Etherchannel Commands
Provide information about the commands used for configuring LAG (Link Aggregation Group) and
LACP (Link Aggregation Control Protocol).
Chapter 9: User Manage Commands
Provide information about the commands used for user management.
Chapter 10: HTTP and HTTPS Commands
Provide information about the commands used for configuring the HTTP and HTTPS logon.
Chapter 11: Binding Table Commands
Provide information about the commands used for binding the IP address, MAC address, VLAN
and the connected Port number of the Host together.
The switch mentioned
1
in this Guide stands for