Calibrating/Jumper Settings - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
J3
* Factory installed positions.
CAUTION:
supply.
4.3

Calibrating/Jumper Settings

The procedures in Sections 4.3 and 4.4 require the use of Control Panel keys on the
OLP. The examples below detail the two types of keypads. Older Control Panels
use Alphabetical keys (Figure 4-1). Newer models use Icons (Figure 4-2).
Refer to these figures when entering key codes from the Control Panel. Both
Alphabetical and Icon representation will be given in the procedures.
FILM DEV
LOW
INPUT TEMP
LEVEL
LEFT INCOR
PROG 15%
Figure 4-1 Old Control Panel with alphabetical key pad.
4-6 Maintenance
A Trigger circuit for Q5 powered from return line
N4
B Trigger circuit for Q5 powered from return line
N3
Closing both S3 and S4 will short circuit the 12V power
FILM
REPL WASTE
INPUT
EMPTY FULL
RIGHT
50% 85%
DEV.
TEMP. REPL.
STDBY
FIX.
TIME
REPL
WAT
DRY AUTO
PAN DRYER MAN
SOUND
LIGHT SAVER REPL
PRESET
+
–
ENTER
ON/
MAN
START OFF