Supply Drive Servo Motor - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual

4.7.1 Supply Drive Servo Motor

Tools Required: Allen wrenches, 1/4" nut driver, 5/16" nut driver
Remove:
1. Unload the media from the system.
2. Open the top cover. Refer to Figure 4-41.
3. If the bridge is installed, put the system in light mode and lift the bridge to
the up position. Shut the system off before the bridge goes back to heavy
mode.
4. Lift up the light shield cover.
Figure 4-41 Imagesetter outer and inner covers.
5. Remove the supply cassettes.
6. Open the right side cover. Refer to Section 4.2.1, Right/Left Side Covers.
7. Remove the outer light shield. Refer to Section 4.6.1, Light Shields (Right
and Left).
4-58 Removal and Replacement
1
2
3
–Top cover. –Bridge. –Light shield.