Removing The Imagesetter Top Cover - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
1.2

Removing the Imagesetter Top Cover

Before the bridge can be installed into the imagesetter, the top cover must be
removed.
Steps
Tools required: Screwdriver
1. At the rear of the imagesetter, remove the allen screws attaching the top
back panel. Refer to Figure 1-1.
2. Raise the top cover.
1
–Top cover. –Hinge stop. –Hinge stop bolt. –Gas shock retaining bolt.
1-2 Installation
1
2
2
Figure 1-1 Rear of the imagesetter.
–Top back panel allen screws.
1