AGFA Avantra 36/44 Service Manual page 219

Avantra 36/44 Service Manual
9. Remove the encoder connector from the supply drive servo motor. Refer to
Figure 4-43.
Note the orientation of the connector for proper replacement.
1
3
Figure 4-43 Removing the supply drive servo motor.
10. Remove the red wire from Pin 1 and the brown wire from Pin 2 on the
motor. Refer to Figure 4-43.
11. Using a 7/64" allen wrench, remove the two (2) allen screws securing the
bottom of the motor to the motor bracket. Refer to Figure 4-43.
12. Using a screwdriver, remove the two (2) hex screws securing the top of the
motor to the sensor flag bracket. Refer to Figure 4-43.
The two hex screws have standoffs between the motor and the bracket.
13. Remove the motor and the sensor flag bracket from the system.
14. Remove the allen screw securing the gear to the motor shaft.
15. Remove the gear.
4-60 Removal and Replacement
2 5 6
4
–Encoder connector. –Red connector.
–Brown connector. –Two 7/64" allen screws.
–Two hex screws. –Flag bracket.