Exhaust Fan - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual

4.4.7 Exhaust Fan

Tools Required: 1/4" nut driver.
Remove:
1. Open the right side covers. See Section 4.2.1, Right/Left Side Covers.
2. Remove the screw securing the wire clamp on the top left corner of the
intake fan assembly (below the exhaust fan). Refer to Figure 4-26.
3. Disconnect the wire connector from the exhaust fan. Refer to Figure 4-25.
4. Cut the tie wraps.
5. Remove the four (4) screws securing the exhaust fan from the electronic
enclosure and remove the assembly.
Replace:
1. Reverse the removal procedures to re-install the exhaust fan.
2. Turn the system power on and check the exhaust fan for proper operation.
4-38 Removal and Replacement
1
Figure 4-25 Exhaust fan location.
–Exhaust fan.