Avantra 36/44 Service Manual
6. Using a phillips screwdriver, remove the two (2) screws holding the rubber
mounts in place.
Replace:
1. Reverse the above removal procedure.
4.8.2 Vacuum Valves
Tools Required: Phillips screwdriver
Remove:
1. Open the right side cover. See Section 4.2.1, Right/Left Side Covers.
2. Using a phillips screwdriver, remove the screw (one each) in the valve
tops. Refer to Figure 4-51.
The valves are located directly to the right of the vacuum pump.
4-70 Removal and Replacement
Figure 4-50 Vacuum pump rubber mounts.
–Rubber mount. –Four rubber mount screws.
1
2