Raising And Lowering The Bridge Into The Imagesetter - AGFA Avantra 36/44 Service Manual

1.4 Raising and Lowering the Bridge into
the Imagesetter
Tools required: 9/16" hex wrench
Steps
1. Swing the crane boom around so that the cable clip is over the capture bar
eyelet. Lower the cable clip to the eyelet.
2. Clip the cable to the eyelet and raise the bridge slowly.
3. When the bridge height exceeds the height of the imagesetter, swing the
boom around. Suspend the bridge over the imagesetter.
4. Before lowering the bridge, grease the V-groove and flat surface on the
detent plates (left and right) located within the imagesetter. Refer to
Figure 1-7.
Use the grease and applicator provided.
Figure 1-7 Lubricating the detent plate V-groove.
1
–Detent plate/V-groove. –Lubricant.
2
Section II: Bridge
Installation 1-7