Operator Control Panel Assembly - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
Replace:
1. Slide the new CSDM into the carriage assembly and secure with the retain-
ing clip.
2. Install the cabling at both ends of the PCB as removed in previous steps.
3. Turn the system on and launch the AVDIAG program from your PC. Select
Test and then Selectable Test. Select Carriage Test and then Carriage.
The carriage should move and pass the test.
4. Run the following imager files:
• Continuous mode:
• Stop/Start mode:

4.4.3 Operator Control Panel Assembly

Tools Required: 1/4" nut driver, 5/16" nut driver
NOTE: Prior to removing the OCP assembly, ensure that the
customer user parameter settings have been saved and a
copy of the OCP FLASHROM software is available for
downloading.
Remove:
1. Turn the system off and unplug the power cord from the outlet.
2. Open the right side doors. See Section 4.2.1, Right/Left Side Covers.
Remove the electronics enclosure cover. See Section 4.2.3, Electronic
Enclosure Cover.
3. Disconnect the OCP ribbon cable from the DEC board. Refer to Figure 4-21.
4-30 Removal and Replacement
1x1 Horizontal Line
50% / 85% / 96% tint