Aperture Wheel Motor - AGFA Avantra 36/44 Service Manual

4. Remove the two (2) hex screws securing the compressor motor to the SGM
casting. Refer to Figure 4-36.
Figure 4-36 Compressor motor location.
–Beam compressor motor. –Beam compressor sensor.
5. Remove the compressor plug from the shell connector removed in Step 3.
Replace:
1. Reverse the removal procedure above.

4.6.7 Aperture Wheel Motor

Tools Required: Small flathead screwdriver, cutters
Remove:
1. Remove the carriage assembly from the system. See Section 4.5, Carriage
Drive Removal/Replacement Procedures.
2. Remove the motor shell connector from the carriage board.
3. Cut all the tie wraps from the aperture wheel motor to the connector
removed in Step 2.
Section I: Imagesetter
2
1
Removal and Replacement 4-53