Dryer Section Temperature Sensor - AGFA Avantra 36/44 Service Manual

6. Pull the cover from the chamber harness and disconnect the connector.
Replace:
1. Reverse the removal procedure above being careful that the distance
between the tank wall and the tip of the sensor does not exceed 1". Refer
to Figure 3-15.

3.11 Dryer Section Temperature Sensor

1. Turn off and unplug the OLP.
2. Remove the top covers.
3. Remove the top back panel.
4. Pull the electronics box straight out on its rollers (see Figure 3-2).
5. Using a socket wrench, loosen the PVC nut.
6. Pull the sensor out. Refer to Figure 3-16.
Figure 3-16 Dryer temperature sensor.
7. Disconnect the connector from the low voltage harness.
Section IV: On-line Processor
1
Removal and Replacement 3-19