AGFA Avantra 36/44 Service Manual page 34

Avantra 36/44 Service Manual
15. Cut the two (2) packing straps around the unit to remove the cardboard
and plastic covers. Refer to Figure 1-6.
2
Figure 1-6 Removing packing materials from the imagesetter.
–Cardboard covering. –Packing straps. –Plastic cover.
16. Open the imagesetter door on the left side. See Chapter 4, Section 4.2.2,
Top, Middle, and Bottom Front Panels.
17. Working within the opened (left) end, position the jack screw provided
(see Figure 1-1) in the access hole in the end cap located at the bottom of
the frame. Refer to Figure 1-7.
18. Before lowering the jack screw to the floor, position the jack screw plate so
that its dimple is directly below the access hole. Refer to Figure 1-7.
CAUTION:
possible damage from the jack screw.
1-10 Installation
1
The jack screw (dimpled) plate protects the floor from
3