AGFA Avantra 36/44 Service Manual page 416

–Terminal strips. –Power board. –Mounting screws.
–X3 connector. –X7 connector. –X1 connector. –X2 connector.
4. Using a small flathead screwdriver, remove the high voltage connectors
from the terminal blocks. Refer to Figure 3-10.
Note the wire labeling for proper replacement.
5. Using a phillips screwdriver, remove the four (4) mounting screws, one at
each corner. Refer to Figure 3-10. Remove the board.
Replace:
1. Reverse the steps in the removal procedure above.
1
4 5
Figure 3-10 Power board.
Section IV: On-line Processor
6 7
Removal and Replacement 3-13
2
3