Setting Up The Dec To Bridge/Buffer Interface - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual

1.5.5 Setting up the DEC to Bridge/Buffer Interface

Tools required: Screwdriver
Steps
1. Using the four standoffs and nylon washers, install the Bridge/buffer inter-
face board on the right wall of the imagesetter. Refer to Figure 1-19.
4
Figure 1-19 Attaching the bridge/buffer interface board.
–Bridge/buffer interface board. –Standoff and nylon washer.
–Interface board cover (attach after connectors are in place).
The interface board should be positioned so that the cable connector
appears on the lower right. Refer to Figure 1-19.
NOTE: Do not attach the cover until the connector plugs are
attached (see steps below).
1-18 Installation
3
–Four hex screws.
1
2