Shuttle Light And Heavy Sensors - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
4.9

Shuttle Light and Heavy Sensors

Tools: Flathead screwdriver
Remove:
1. Using a flathead screwdriver, remove the two (2) mounting screws. Refer
to Figure 4-8.
1
Figure 4-8 Shuttle light and heavy sensor assembly.
–Bridge shuttle motor. –Cover. –Shuttle light and heavy sensor assembly.
–Two mounting screws. –Two sensor assembly connectors.
2. Remove the two (2) sensor connectors. Refer to Figure 4-8.
3. Remove the single screw securing the sensors in place.
Replace:
1. Reverse the above procedures.
2. Put the system through a practice run to make certain that the sensors run
properly.
4-10 Removal and Replacement
2
3
4
5