Setting Up The Debugger Port - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
3.2

Setting Up the Debugger Port

Access the bridge debugger port software using a terminal or PC running terminal
emulation software (Procomm). The bridge/buffer module uses a 15-pin D-type
connector requiring a special adapter cable to interface to the standard serial cable.
Refer to Figure 3-1.
15 PIN MALE
D-TYPE
To Buffer/Bridge Module
Figure 3-1 Avantra 36/44 Bridge Diagnostic Adapter Cable.
Use the following parts to interface from a PC to the bridge debugger port:
• 9-pin female connector (PC end)
• 25-pin male connector (imagesetter end)
• cable
• bridge diagnostic adapter cable
3-2 Diagnostics
TX
2
RX
3
GND
6
25 PIN FEMALE
D-TYPE
2
3
7
To Terminal Serial Cable
78448-015
78448-016
78448-008
C03546-501