Software Installation - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
Direct Connect:
• Avantra diagnostic software
• 9-pin female connector (PC end)
• 25-pin male connector (imagesetter end)
• Cable
* This may not be the latest revision of software. Refer to OMNI Bulletin Board for latest revision of
AVDIAG Program.
Remote:
Refer to Section 3.4, for a detailed list of requirements.

3.3.2 Software Installation

The software installation procedure for the Avantra Diagnostic software is simple
and quick. The software comes on one (1) 3.5" floppy disk. The software includes
the Avantra diagnostic executable file and a set of predefined command files. Use
the following procedure to install the software:
1. Turn the PC on and wait for the DOS prompt.
2. Insert the Avantra Diagnostic software floppy disk into the drive.
3. Type in the following:
C:> a:install c:\avantra <RETURN>
Install.bat is a self extracting compressed file that creates all the required
directories and sub-directories on the PC's hard disk and copies the
Avantra Diagnostic files to the appropriate places. The following directo-
ries are created on the hard disk:
4. After the files have been successfully copied to the hard disk, remove the
Avantra Diagnostic software diskette from the floppy drive.
3-18 Diagnostics
c:\avantra\default
c:\avantrag\cmd
c:\avantra\download
700594-1003*
78448-015
78448-016
78448-008