AGFA Avantra 36/44 Service Manual page 194

2
7
1
–Intake fan. –Exhaust fan. –Power connector to control panel.
– –
Power supply. AC power connector.
6. Remove the cable clamp on the intake fan securing the cable wires. Refer
to Figure 4-23.
7. Disconnect the connector going to the exhaust fan. Refer to Figure 4-23.
8. Remove the cable clamp on the rear panel and disconnect the two connec-
tors going to the bottom drum fan assembly and to the door interlock
switches.
9. Cut the tie clamps releasing the exhaust fan cable from the cable harness.
10. Remove the power connector to the DEC board. Refer to Figure 4-23.
Figure 4-23 Power supply.
–
Power connector to DEC Board.
–
Three hex screws under shelf.
Section I: Imagesetter
4
5
6
Removal and Replacement 4-35
3