AGFA Avantra 36/44 Service Manual page 263

Avantra 36/44 Service Manual
6.2.3.6 Bridge Cleaning
If the optional bridge is installed, it should be cleaned during every preventive
maintenance.
To Clean:
1. Open the top cover and remove the three bridge covers by lifting the two
latches on each side.
2. Soft vacuum the:
• Three top covers (both sides)
• Bridge rollers
• Platen between the bridge rollers
3. Lift the bridge to the up position and vacuum the labyrinth opening.
4. Lower the bridge and install the three top covers.
6.2.3.7 Buffer
If the Buffer is installed, it should be checked and cleaned during every
preventive maintenance.
To Clean:
1. Remove the top cover.
2. Remove both the left and right side covers.
3. Move the buffer carriage to the processor side and clean both rollers using
clear masking tape.
4. Move the buffer carriage assembly to the bridge side and make sure that
the carriage butts up evenly on both ends.
If one end hits the stop before the other, then the carriage rails may need
to be re-aligned. Refer to Chapter 2 in Section III, Buffer.
5. Remove media at the bottom of the buffer.
6. Re-install side panels and covers.
6-8 Maintenance