AGFA Avantra 36/44 Service Manual page 254

Avantra 36/44 Service Manual
1
2
ROW
3
4
5
3. On the "User Defaults" screen, set the user feed length to 44".
4. Go to the "Utility" screen and execute a "User Feed". The number of loops
appears in the lower right of the "User Feed" icon in the center of the
screen. When the feed is complete the number gets updated. This number
represents the number of slack loops completely formed (i.e. slack loop
formed and unformed).
5. The number of slack loops formed for a 44" feed should be at least 11. Per-
form several "User Feeds" to determine an average number of loops
formed. If the number is less than four, go to Step 6. If there are only four
to ten slack loops, the bridge speed parameters should be adjusted. Per-
form the following steps:
a. Using AVDIAG, download the "DEC Machine Parameters". Select
"Image/Focus/Bridge" and locate the Bridge parameters.
b. Adjust the following parameters up or down accordingly, by steps of
approximately 50.
Ubr Fast Sp Thin - 4500 (nominal)
Ubr Slow Sp Thin - 6500 (nominal)
NOTE: Raising the number decreases the speed. Lowering the
number increases the speed.
5-22 Alignment
1 2 3
Look Fix Save
Cass 1 P 0 = 00000000h
Cass 1 P 1 =
00000000h
Cass 1 P 2 =
00000000h
P 3 = 00000000h
Cass 1
P 4 =
Cass 1
00000000h
P 5 =
Cass 1
00000000h
00000000h
P 6 =
Cass 1
P 7 =
00000000h
Cass 1
P 8 =
Cass 1 00000000h
A) Press button 6, 3 to toggle
Test ON/Off first
B) Press button 6, 1 to Exit
Figure 5-7 Exiting the Secret Screen.
4 5 6
Errors
are On
Feed
is On
Buffer
Slack
On/not
Loop
in use
On
Proc
OCP
On/not
DEC
in use
Off
B
A