AGFA Avantra 36/44 Service Manual page 35

1
2
3
Figure 1-7 Using the jack screw and plate for raising the imagesetter (left
–End plate. –Jack screw. –Jack screw (dimpled) plate.
–Outer bolt (1 of 2). –Spring clip.
19. Turn the jack screw until the unit begins to lift on the plate. Raise the unit
only an inch from the ground.
20. Release the unit from the pallet by removing the two (2) outer bolts and
their spring clips. Refer to Figure 1-7.
CAUTION:
Leave the door slightly ajar before lowering the unit.
Doing so prevents the door fom hitting the floor first.
21. Lower the unit to the floor by turning the jack screw.
NOTE:
Use the breaker bar on the wrench handle, if necessary.
side).
–Skid.
Section I: Imagesetter
5
4
6
Installation 1-11