AGFA Avantra 36/44 Service Manual page 339

Avantra 36/44 Service Manual
6. Connect the cable to the sensor on the extension platen prior to installing
the extension platen.
7. Insert the extension platen through the opening and position the platen at
the inside rear of the imagesetter. Refer to Figure 1-10 and Figure 1-11.
8. Hang the platen brackets on the studs jutting from the imagesetter frame.
9. Remove the imagesetter plastic access panels (left and right) to get at the
studs and brackets. Attach the brackets left and right to the studs using the
two (2) nuts provided. Refer to Figure 1-11.
Figure 1-11 Attaching the extension platen to the imagesetter.
–Inside rear of imagesetter. –Extension platen brackets.
–One of two imagesetter access covers (left and right). –Hex nuts attaching
brackets to the extension platen (four at the top) and the inside rear of the
imagesetter (two at the bottom). Do not tighten the nuts.
1-12 Installation
1
2
3
4