AGFA Avantra 36/44 Service Manual page 138

3.3.4.2 Save/Restore DEC DSP and DEC Correction Tables
(DEC FLASHROM)
Use this procedure to save DEC DSP and DEC correction tables or to restore them
to the DEC FLASHROM.
To Save:
1. Connect the PC to the diagnostic serial port of the system.
2. Turn the system on and allow the boot cycle to complete.
3. Launch the AVDIAG Program from your PC.
4. Select FLASHROM and then Save CORR table.
5. A dialog box appears for Pathname/Filename. Press ENTER.
6. The Pathname/Filename appears using the system serial number and
extension. Press ENTER.
The DEC correction tables will be saved to the PC.
NOTE:
If you have previously saved the DEC (DSP) software or
have a newer revision, store in AVDIAG, then you do not
have to save it again.
7. Select FLASHROM and then Save DSP code.
8. A dialog box appears for the Pathname/Filename. Press ENTER.
9. The Pathname/Filename appears. Press ENTER.
The DEC DSP is saved to the PC.
Section I: Imagesetter
Diagnostics 3-51