Attaching The Bridge To The Imagesetter; Attaching The Bridge Foot - AGFA Avantra 36/44 Service Manual

9. Remove the two (2) screws from the capture bar bracket, left and right (see
Figure 1-6). Remove the side brackets and return the screws to the sides of
the bridge.
10. Replace the light shields at the top of the bridge.
1.5

Attaching the Bridge to the Imagesetter

This section explains how to attach the bridge to the imagesetter including the
following procedures:
•

Attaching the bridge foot

• Attaching the gas shocks
• Adjusting the detent plate
• Attaching and aligning the solid stops
• Setting up the DEC to bridge/buffer interface
• Attaching the anti-static wires
1.5.1 Attaching the Bridge Foot
Tools required: None
Steps
1. Position the bridge foot on the take-up platform of the imagesetter. Lower
the bridge and align the bridge body with the foot.
2. Using the foot thumb screws (left and right), attach the foot to the bridge.
Refer to Figure 1-9.
Section II: Bridge
Installation 1-9