Inner Take-Up Drive (Nip) Motor - AGFA Avantra 36/44 Service Manual

Avantra 36/44 Service Manual
5. Enter Display Sensors from the Align menu and check the operation of the
take-up jam sensor.
The take-up jam sensor can be checked by inserting a piece of film down
the right side of the take-up cassette platform until the sensor wheels
move, which causes a change in status.
6. Load the media to check the complete feed function.

4.3.4 Inner Take-up Drive (Nip) Motor

Tools Required: 3/16" allen wrench, 1/4" and 5/16" nut driver
Remove:
1. Unload the media and turn the system off.
2. Open the top cover.
3. Remove the top and middle front panels. See Section 4.2.2, Top, Middle
and Bottom Front Panels.
4. Remove the take-up light shield. See Section 4.3.1, Take-up Light Shield.
5. Remove the foam on either side of the outer take-up (nip) drive.
6. Remove the outer take-up (nip) drive. See Section 4.3.2, Outer Take-up
Drive (Nip) Assembly.
7. Remove the inner take-up drive. See Section 4.3.3, Inner Take-up Drive
(Nip) Assembly.
4-14 Removal and Replacement