Questionable Event Registers - Keithley 3700 series Reference Manual

Series 3700 System Switch/Multimeter Reference Manual
Commands
To set register bits:
status.operation.user.* = status.operation.user.BIT0
status.operation.user.* = status.operation.user.BIT1
status.operation.user.* = status.operation.user.BIT2
status.operation.user.* = status.operation.user.BIT3
status.operation.user.* = status.operation.user.BIT4
status.operation.user.* = status.operation.user.BIT5
status.operation.user.* = status.operation.user.BIT6
status.operation.user.* = status.operation.user.BIT7
status.operation.user.* = status.operation.user.BIT8
status.operation.user.* = status.operation.user.BIT9
status.operation.user.* = status.operation.user.BIT10
status.operation.user.* = status.operation.user.BIT11
status.operation.user.* = status.operation.user.BIT12
status.operation.user.* = status.operation.user.BIT13
status.operation.user.* = status.operation.user.BIT14
To read registers:
print(status.operation.user.*)
print(status.operation.user.condition)
print(status.operation.user.event)

Questionable event registers

The Series 3700 has six register sets associated with questionable event status. As an example
to set the CAL enable bit, use either of the following commands:
status.questionable.enable = status.questionable.CAL
status.questionable.enable = 256
The following command will request the questionable enable register value:
print(status.questionable.enable)
Refer to the
read the bits in the questionable event registers.
Document Number: 3700S-901-01 Rev. A / August 2007
status.questionable.* (on page 9-195) ICL command for the attributes to control and
Section 8: Status Model
Bit
B0
B1
B2
B3
B4
B5
B6
B7
B8
B9
B10
B11
B12
B13
B14
8-19