Range
The range setting is ―remembered‖ by each measurement function. Selecting a function returns
the instrument to the last range setting for that function.
NOTE
Measurement ranges and maximum readings
The range that is selected affects both measurement accuracy as well as the maximum
measurable level. Input values that exceed the maximum readings cause ―Overflow‖ to be
displayed.
Function
DCV (DC voltage)
ACV (AC voltage)
DCI (DC current)
ACI (AC current)
2 (two-wire ohm)
4 (four-wire ohm)
4 OC (four-wire ohm offset
compensated)
4 DRY+ (four-wire ohm
dry circuit)
TMP (temperature)
FREQ (frequency)
PER (period)
Range, Digits, Rate, Bandwidth, and Filter
In this section:
Range ............................................................................................................. 4-1
Digits ICL programming ................................................................................... 4-3
Rate ............................................................................................................... 4-4
Bandwidth ....................................................................................................... 4-6
Filter ............................................................................................................... 4-6
A power cycle or an instrument reset will reset "remembered" ranges.
Ranges
100mV, 1V, 10V, 100V, 300V
100mV, 1V, 10V, 100V, 300V
10µA, 100µA, 1mA, 10mA,
100mA, 1A
1mA, 10mA, 100mA, 1A
10, 100, 1k, 10k, 100k,
1M, 10M, 100M
1, 10, 100, 1k, 10k,
100k, 1M, 10M, 100M
1, 10, 100, 1k, 10k
1, 10, 100, 1k, 10k
-200°C to 1820°C
3Hz to 500kHz
2µs to 333ms
Maximum reading
± 303V
± 303V
± 3.1A
± 3.1A
120M
120M
12k
2.4k
Sensor dependent
Section 4