Trigger.blender - Keithley 3700 series Reference Manual

Section 9: Instrument Control Library (ICL)
trigger.wait
Example

trigger.blender

Use the functions in this group to control event blender triggering.
trigger.blender[N].clear
Function
Usage
trigger.blender[N].orenable
Attribute
Usage
Remarks
trigger.blender[N].overrun
Attribute
Usage
9-216
Waits up to 10 seconds for a trigger:
triggered = trigger.wait(10)
print(triggered)
Output: false
The above output indicates that no trigger was detected during the 10 second timeout.
This function clears and resets the blender.
trigger.blender[N].clear()
N: (In) The trigger line (1–2).
Set acceptor attribute.
To read the trigger blender acceptor mode:
orenable = trigger.blender[N].orenable
To write the trigger blender acceptor mode:
trigger.blender[N].orenable = orenable
orenable: Measure count value presently being used or to set
N: (In) The trigger line (1–2).
This attribute selects whether the blender will wait for any one event (or-mode) or will
wait for all selected events (and-mode) before signaling an output event.
Set this attribute to true for or-mode.
Set this attribute to false for and-mode.
This attribute provides the event detector overrun status.
overrun = trigger.blender[N].overrun
N: (In) The trigger line (1–2).
overrun: (Out) Trigger overrun state.
Series 3700 System Switch/Multimeter Reference Manual
Document Number: 3700S-901-01 Rev. A / August 2007