Keithley 3700 series Reference Manual page 357

Series 3700 System Switch/Multimeter Reference Manual
tsplink.trigger[N].mode
Attribute
Usage
Remarks
Also see
tsplink.trigger[N].overrun
Attribute
Usage
Document Number: 3700S-901-01 Rev. A / August 2007
The trigger operation/detection mode.
To read trigger operation/detection mode:
mode = tsplink.trigger[N].mode
To write trigger operation/detection mode:
tsplink.trigger[N].mode = mode
N: (In) The trigger line (1–3).
mode: (In/Out) Trigger mode.
This attribute controls the mode in which the trigger event detector as well as the
output trigger generator will operate on the given trigger line. mode can be one of the
following values:
tsplink.TRIG_FALLING
Detect falling edge triggers as input. Assert a TTL-low pulse for output.
tsplink.TRIG_EITHER
Detect rising or falling edge triggers as input. Assert a TTL-low pulse for output.
tsplink.TRIG_SYNCHRONOUSA
Detect falling edge triggers as input and automatically latch and drive them low when
detected. Release a latched line for output.
tsplink.TRIG_SYNCHRONOUSM
Detect rising edge triggers as input. Assert a TTL-low pulse for output.
tsplink.trigger[N].assert (on page 9-212)
tsplink.trigger[N].clear (on page 9-212)
tsplink.trigger[N].overrun
tsplink.trigger[N].release
tsplink.trigger[N].triggersource
tsplink.trigger[N].wait (on page 9-214)
Event detector overrun status.
overrun = tsplink.trigger[N].overrun
overrun: (Out) Trigger overrun state.
N: (In) The trigger line (1–3).
Section 9: Instrument Control Library (ICL)
(on page 9-213)
(on page 9-214)
(see "tsplink.trigger[N].triggerstimulus" on page 9-214)
9-213