Keithley 3700 series Reference Manual page 361

Series 3700 System Switch/Multimeter Reference Manual
trigger.blender[N].overrun
Remarks
trigger.blender[N].stimulus[N]
Attribute
Usage
Remarks
trigger.blender[N].wait
Document Number: 3700S-901-01 Rev. A / August 2007
This attribute is a read-only attribute that indicates if an event was ignored because the
event detector was already in the detected state when the event occurred. This is an
indication of the state of the event detector built into the event blender itself.
This attribute does not indicate if an overrun occurred in any other part of the trigger
model or in any other construct that is monitoring the event. It also is not an indication
of an event overrun.
This attribute provides event detector trigger selection.
To read blender and trigger source number:
eventid = trigger.blender[N].stimulus[M]
To write blender and trigger source number:
trigger.blender[n1].stimulus = eventid
N: (In) Event blender number (1–2).
M: (In) Trigger source number (1-4).
eventid: (In/Out) Event to trigger the source action.
This attribute selects which events will trigger the blender. There are 4 acceptors that
can each select a different event.
eventid may be one of the following (existing trigger event ID's):

digio.trigger[line].EVENT_ID: An edge (either rising, falling, or either based on the
configuration of the line) on the digital input line.

display.trigger.EVENT_ID: The trigger key on the front panel is pressed.

trigger.EVENT_ID: A *trg message on the active command interface. If GPIB is
the active command interface, a GET message will also generate this event.
Also, the trigger.set function will generate this event.

trigger.blender[N].EVENT_ID: A combination of events has occurred.

trigger.timer[N].EVENT_ID: A delay expired. These can be expanded to include
LXI alarms.

tsplink.trigger[N].EVENT_ID: An edge (either rising, falling, or either based on
the configuration of the line) on the tsplink trigger line.

lan.trigger[N].EVENT_ID

scan.trigger.EVENT_SCAN_READY: Scan Ready Event.

scan.trigger.EVENT_SCAN_START: Scan Start Event

scan.trigger.EVENT_CHANNEL_READY: Channel Ready Event

scan.trigger.EVENT_MEASURE_COMP: Measure Complete Event

scan.trigger.EVENT_SEQUENCE_COMP: Sequence Complete Event

scan.trigger.EVENT_SCAN_COMP: Scan Complete Event

scan.trigger.EVENT_IDLE: Idle Event
Section 9: Instrument Control Library (ICL)
9-217