Keithley 3700 series Reference Manual page 291

Series 3700 System Switch/Multimeter Reference Manual
lan.trigger[N].stimulus
Usage
Remarks
Also see
Example
Document Number: 3700S-901-01 Rev. A / August 2007
To read the trigger source:
trigstim =
lan.trigger[N].stimulus
packet: The trigger packet over LAN to query for stimulus setting.
trigstim: The event identifier being used to trigger the event.
To write the trigger stimulus:
lan.trigger[N].stimulus =
trigstim
N: The trigger packet over LAN for which to set the trigger source (1–8).
trigstim: The event identifier to set as the trigger event stimulus.
This attribute selects which event will cause a LAN trigger packet to be sent for this
trigger. The events may be one of the following:
trigstim may be one of the following (existing trigger event ID's):

digio.trigger[line].EVENT_ID: An edge (either rising, falling, or either based on the
configuration of the line) on the digital input line.

display.trigger.EVENT_ID: The trigger key on the front panel is pressed.

trigger.EVENT_ID: A *trg message on the active command interface. If GPIB is
the active command interface, a GET message will also generate this event. Also,
the trigger.set function will generate this event.

trigger.blender[N].EVENT_ID: A combination of events has occurred.

trigger.timer[N].EVENT_ID: A delay expired. These can be expanded to include
LXI alarms.

tsplink.trigger[N].EVENT_ID: An edge (either rising, falling, or either based on the
configuration of the line) on the tsplink trigger line.

lan.trigger[N].EVENT_ID

scan.trigger.EVENT_SCAN_READY: Scan Ready Event.

scan.trigger.EVENT_SCAN_START: Scan Start Event

scan.trigger.EVENT_CHANNEL_READY: Channel Ready Event

scan.trigger.EVENT_MEASURE_COMP: Measure Complete Event

scan.trigger.EVENT_SEQUENCE_COMP: Sequence Complete Event

scan.trigger.EVENT_SCAN_COMP: Scan Complete Event

scan.trigger.EVENT_IDLE: Idle Event
lan.trigger[N].assert (on page 9-143)
lan.trigger[N].clear (on page 9-144)
lan.trigger[N].overrun (on page 9-146)
lan.trigger[N].wait (on page 9-147)
To use a timer trigger event as the source for LAN packet 5 trigger:
lan.trigger[5].triggersource =
trigger.timer[1].EVENT_ID
Section 9: Instrument Control Library (ICL)
9-147