Keithley 3700 series Reference Manual page 290

Section 9: Instrument Control Library (ICL)
lan.trigger[N].mode
Example
lan.trigger[N].pseudostate
Attribute
Usage
Remarks
Example
lan.trigger[N].overrun
Attribute
Usage
Remarks
Also see
Example
lan.trigger[N].stimulus
Attribute
9-146
To see the present LAN trigger mode of lanevent 1 :
print(lan.trigger[1].mode)
Sets the simulated line state for the LAN trigger.
To read the simulated line state for the LAN trigger:
pseudostate = lan.trigger[lanevent].pseudostate
To write the simulated line state for the LAN trigger:
lan.trigger[lanevent].pseudostate = pseudostate
lanevent: The LAN event number (1-8).
pseudosate: The simulated line state (0 or 1).
This attribute tracks the simulated line state of the LAN trigger. The value can be set to
initialize the pseudo state to known value. Setting this attribute will not cause the LAN
trigger to generate any events or output packets. ON or OFF cannot be used when
setting the pseudosate.
To display the present simulated line state for the LAN event 1:
print(lan.trigger[lanevent].pseudostate)
Event detector overrun status.
overrun = lan.trigger[N].overrun
N: The trigger packet over LAN to check overrun status (1–8).
overrun: The trigger overrun state for the LAN packet specified.
This attribute is a read-only attribute that indicates if an event was ignored because the
event detector was already in the detected state when the event occurred. This is an
indication of the state of the even detector built into the synchronization line itself. It
does not indicate if an overrun occurred in any other part of the trigger model, or in any
other construct that is monitoring the event. It also is not an indication of an output
trigger overrun. Output trigger overrun indications are provided in the status model.
lan.trigger[N].assert (on page 9-143)
lan.trigger[N].clear (on page 9-144)
lan.trigger[N].triggersource
lan.trigger[N].wait (on page 9-147)
To check the overrun status of a trigger with LAN packet 5:
overrun = lan.trigger[5].overrun
Event to cause this trigger to assert.
Series 3700 System Switch/Multimeter Reference Manual
(on page 9-146)
Document Number: 3700S-901-01 Rev. A / August 2007