Tsplink.trigger[N].Triggerstimulus - Keithley 3700 series Reference Manual

Section 9: Instrument Control Library (ICL)
tsplink.trigger[N].overrun
Remarks
Also see
tsplink.trigger[N].release
Function
Usage
Remarks
Also see

tsplink.trigger[N].triggerstimulus

tsplink.trigger[N].stimulus
Attribute
Usage
Remarks
9-214
This attribute is a read-only attribute. It indicates if an event was ignored due to the
event detector being in the detected state when the event occurred. This is an
indication of the state of the event detector built into the synchronization line itself.
This attribute does not indicate:

If an overrun occurred in any other part of the trigger model or in any other
construct that is monitoring the event.

An output trigger overrun. Output trigger overrun indications are provided in the
status model.
tsplink.trigger[N].assert (on page 9-212)
tsplink.trigger[N].clear (on page 9-212)
tsplink.trigger[N].mode (on page 9-212)
tsplink.trigger[N].release
tsplink.trigger[N].triggersource
tsplink.trigger[N].wait (on page 9-214)
Release a latched trigger.
tsplink.trigger[N].release()
N: (In) The trigger line (1–3).
This function will release a latched trigger on the given TSP-Link trigger line.
tsplink.trigger[N].assert (on page 9-212)
tsplink.trigger[N].clear (on page 9-212)
tsplink.trigger[N].mode (on page 9-212)
tsplink.trigger[N].overrun
tsplink.trigger[N].triggersource
tsplink.trigger[N].wait (on page 9-214)
Event to cause this trigger to assert.
tsplink.trigger[N].stimulus()
N: (In) The trigger line (1–3).
This attribute selects which event will cause the synchronization line to assert a trigger.
Series 3700 System Switch/Multimeter Reference Manual
(on page 9-214)
(see "tsplink.trigger[N].triggerstimulus" on page 9-214)
(on page 9-213)
(see "tsplink.trigger[N].triggerstimulus" on page 9-214)
Document Number: 3700S-901-01 Rev. A / August 2007