Keithley 3700 series Reference Manual page 69

Series 3700 System Switch/Multimeter Reference Manual
MATH
Selecting the MATH menu item opens the MATH MENU. Items contained in this menu are as
follows:






NPLC
Configures the integration rate in line cycles for the DMM. Related ICL command:
page 9-105)
OFFSETCOMP
Configures the offset compensation setting for the DMM. Related ICL command:
dmm.offsetcompensation
OPENDETECT
Configures the state of the thermocouple or four-wire ohms open detector being used. Related
ICL command:
RANGE
Configures the range of DMM for the selected function. Related ICL command:
page 9-108)
REL
Opens the REL MENU for the selected DMM function. See
15).
Document Number: 3700S-901-01 Rev. A / August 2007
ENABLE: Enable or disable math operation on measurements. Related ICL command:
dmm.math.enable (on page 9-99)
FORMAT: Specifies the math operation to perform on measurements. Related ICL
command: dmm.math.format
BFACTOR: Specifies the offset for the y = mx + b operation. Related ICL command:
dmm.math.mxb.bfactor
MFACTOR: Specifies the scale factor for the y = mx + b operation. Related ICL
command: dmm.math.mxb.mfactor
MXBUNITS: Specifies the unit character for the y = mx + b operation. Related ICL
command: dmm.math.mxb.units
PERCENT: Specifies the constant to use for the percent operation. Related ICL
command: dmm.math.percent
(on page 9-105)
dmm.opendetector
(on page 9-100)
(on page 9-101)
(on page 9-101)
(on page 9-102)
(on page 9-102)
(on page 9-108)
Section 3: Using the Front Panel
dmm.range
REL key configuration
dmm.nplc (on
(on
(on page 3-
3-13