Connecting The Power Cable; Setting Ink - MIMAKI TS55-1800 Operation Manual

Connecting the power cable

1
Insert the power cable into an inlet of the
machine.
2
Secure a cable band.
• Secure the cable with the cable band attached to
this machine.
3
Insert the power plug into a plug socket.
Power plug
• Do not use any power cables other than the
attached power cable.
• Be sure to connect the power cable to the outlet
near this machine, and make sure that the power
cable can be easily removed.
• Connect the power cable to the grounded
outlet.Otherwise, it may result in fire or an electric
shock.
Inlet
Power cable
Cable band
Socket

Setting Ink

You can use aqueous sublimation dye ink (Sb610) for this
machine.
1
Take out the 2L ink pack.
• Take out the 2L ink pack and the ink IC chip from
a small cardboard box.
ink IC chip
2
Mount the ink IC chip.
• Be careful of the ink IC chip direction. If
it is set in the wrong direction, ink is not
supplied properly.
• Make the metal side up.
• Do not touch the metal part while
inserting. (The ink IC chip may be
damaged by static electricity.)
、
3
Take out an 2L ink pack and gently shake it
from side to side at least 20 times.
• While wearing gloves, hold the cap of the 2L ink
pack tightly with a paper towel or a similar object,
and then gently shake the bottle from side to side
at least 20 times to let the ink flow inside the
bottle.
• Be sure to wear gloves and work.
• Remember to shake the bottle gently.
Shaking the bottle violently can cause
the ink to leak out.
• When the remaining ink is low, tilt the ink
bottle all the way to the right and left until
the bottle is in the upright position to
ensure that the ink inside the 2L ink pack
is thoroughly mixed.
Chapter 1 Before Use
2L ink pack
ink IC chip
1-11
1
2
2
2
5
6