Replacing A Cd-Rom/Tape Drive; Replacing The Bracket Into The Chassis - Sun Microsystems Ultra 1 Series Service Manual

See Figure 9–7.
Figure 9–7
2. Remove the four screws securing the CD-ROM/tape drive to the drive bracket.
See Figure 9–7.
3. Remove the CD-ROM/tape drive, and place it aside.
1. Position the CD-ROM/tape drive on an antistatic surface. Align it on the edge
of the surface.
See Figure 9–7.
2. Position the bracket on top of the CD-ROM/tape drive. If your system has a
diskette drive, it is assembled on the bracket.
3. Replace the four screws to secure the CD-ROM/tape drive to the bracket.
1. Place the drive bracket on top of the disk drive bay.
See Figure 9–8.
2. Connect the SCSI cable to the CD-ROM/tape drive (if present).
Sun Ultra 1 Series Service Manual ♦ Revision A, November 1995
76
Positioning the CD-ROM/Tape Drive