Internal Access; Disconnecting The External Cables - Sun Microsystems SPARCclassic Service Manual

7
CHAPTER

Internal Access

This chapter describes how to access the subassemblies inside the system unit, and
how to close the system unit after you have finished.
4 "Disconnecting the External Cables" on page 51
4 "Opening the System Unit" on page 52
4 "Attaching the Wrist Strap" on page 53
4 "Closing the System Unit" on page 55
4 "Reconnecting the External Cables" on page 57

Disconnecting the External Cables

Detach all cables connected to the rear of the system unit. Take care to remember
where each cable attaches to the system unit.
Note -
Do not disconnect the power cord from the system unit's power receptacle.
The power cord should remain connected to a grounded power outlet.
To disconnect the SCSI cable:
1. Press in on both the finger clips of the connector that attaches the device to the
system unit.
2. Pull the connector off.
51