Table of Contents
Advertisement
After you install the compute node cover, install the compute node into the chassis
(see "Installing a compute node in a chassis" on page 97 for instructions).
Removing the air baffle
Use this information to remove the air baffle.
To remove the air baffle, complete the following steps:
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 93.
2. Turn off the compute node and peripheral devices and disconnect the power
cords and all external cables (see "Turning off the compute node" on page 16).
3. Remove the cover (see "Removing the compute node cover" on page 110).
4. Grasp the air baffle, disengage pins from pin holes; then, lift the air baffle up.
Left air baffle
Figure 25. Air baffle removal (compute node)
Figure 26. Air baffle removal (GPU tray)
5. Remove the air baffle from the compute node/GPU tray and set it aside.
Attention: For proper cooling and airflow, replace the air baffle before you
turn on the compute node. Operating the compute node with the air baffle
removed might damage compute node components.
Right air baffle
Air baffle
Chapter 5. Removing and replacing components
113
Advertisement
Table of Contents
Troubleshooting
