Removing The Air Baffle From A 9008-22L, 9009-22A, Or 9223-22H System - IBM Power Systems 9008-22L Manual

Figure 31. Installing the service access cover
Removing the air baffle from a 9008-22L, 9009-22A, or 9223-22H
system
Use this procedure to remove the air baffle from a IBM Power System L922 (9008-22L), IBM Power
System S922 (9009-22A), or IBM Power System H922 (9223-22H) server.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Lift each air baffle (A) straight up. See Figure 32 on page 44.
Place air baffles upside down on a clean area so that the foam does not collect contaminants. When
you turn an air baffle over, hold the detachable drive cover to prevent it from coming loose.
Common procedures for removing or replacing the system processor module
43