Removing The 2.5-Inch Hot-Swap Rear Hard Disk Drive Kit - IBM System x3550 M5 Type 5463 Installation And Service Manual

Removing the 2.5-inch hot-swap rear hard disk drive kit

Use this information to remove the 2.5-inch hot-swap rear hard disk drive kit.
About this task
To remove the 2.5-inch hot-swap rear hard disk drive kit, complete the following
steps.
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 126).
4. Disconnect the mini-SAS HD (12Gb) and power cables from the 2.5-inch
Figure 59. Mini-SAS HD (12Gb) and power cable disconnection
5. Lift the air duct and disconnect the mini-SAS HD (12Gb) and power cables
148
IBM System x3550 M5 Type 5463: Installation and Service Guide
"Installation guidelines" on page 122.
hot-swap hard disk drive backplane and power connector.
from the rear hot-swap backplane.
SAS/SATA power cable
SAS/SATA signal
cables