Table of Contents
Advertisement
Figure 130. DIMM connectors location
To install a DIMM, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2.
Turn off the server (see "Turning off the server" on page 22) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3.
Remove the top cover (see "Removing the server top cover" on page 188).
Step 4.
Touch the static-protective package that contains the DIMM to any unpainted metal surface on the
outside of the server. Then, remove the DIMM from the package.
Step 5.
Open the retaining clip on each end of the DIMM connector.
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, open and
close the clips gently.
216
Lenovo System x3530 M4 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
