Replacing The Cd/Dvd Cable - Lenovo x3530 M4 Installation And Service Manual

Step 4. Remove the air baffle (see "Removing the air baffle" on page 192).
Step 5. Remove the CD/DVD drive (see "Removing a CD/DVD drive" on page 206).
Step 6. From the front of the server, grasp the cable connector latch and pull it up toward the rear of the
server; then, slide the cable connector to the unlock position.
Figure 125. CD/DVD drive cable removing
Step 7. Remove the cable from the optical drive cage connector.
Step 8. Disconnect the other end of the CD/DVD cable from the connector on the system board.
Step 9. Disengage the cable clips and remove the CD/DVD cable from the server.
Step 10. If you are instructed to return the CD/DVD cable, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Replacing the CD/DVD cable

Use this information to install a CD/DVD cable.
To install the CD/DVD cable, complete the following cable:
Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2. Align the cable connector with the connector on the rear of the optical drive cage and press the
cable connector into the optical drive cage connector.
Step 3. From the front of the server, grasp the cable connector latch and pull it up toward the rear of the
server; then, slide the cable connector to the lock position.
.
Chapter 6 Removing and replacing structural parts
211