Table of Contents
Advertisement
Figure 138. USB hypervisor flash device installation
Step 4.
Reconnect the power cord and any cables that you removed.
Step 5.
Install PCI riser-card assembly 1 (see "Replacing a PCI riser-card assembly" on page 242).
Step 6.
Install the air baffle (see "Replacing the air baffle" on page 192).
Step 7.
Install the cover (see "Replacing the server top cover" on page 189).
Step 8.
Reconnect the power cord and any cables that you removed.
Step 9.
Turn on the peripheral devices and the server.
Removing a hot-swap power supply
Use this information to remove a hot-swap power supply.
When you remove or install a hot-swap power supply, observe the following precautions.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power
224
Lenovo System x3530 M4 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
