Figure 50. Redundant power information label
Installing a USB embedded hypervisor flash device
Use this information to install a USB embedded hypervisor flash device.
To install a hypervisor flash device, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2.
Turn off the server (see "Turning off the server" on page 22) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3.
Remove the top cover (see "Removing the server top cover" on page 33).
Step 4.
Remove PCIe riser-card assembly 1 (see "Removing a PCI riser-card assembly" on page 241).
Step 5.
Locate the embedded hypervisor USB flash device connector on the system board as shown
in the following illustration:
.
Chapter 2
Installing optional devices
65