Operator Information Panel - Lenovo x3530 M4 Installation And Service Manual

drive is being rebuilt. When the LED is flashing rapidly (three flashes per second), it indicates that the
controller is identifying the drive.
• Hard disk drive activity LEDs: These LEDs are used on SAS or SATA hard disk drives. Each hot-swap
drive has an activity LED, and when this LED is flashing, it indicates that the drive is in use.
• CD-RW/DVD eject button (Optional): Press this button to release a DVD or CD from the CD/DVD drive.
• CD-RW/DVD drive activity LED (Optional): When this LED is lit, it indicates that the CD-RW/DVD
drive is in use.
• Operator information panel: This panel contains controls and LEDs that provide information about the
status of the server. For information about the controls and LEDs on the operator information panel, see
"Operator information panel" on page 15.
• Operator information panel release button (Optional): This release button is on the advanced operator
information panel. Push the blue release button and pull out the light path diagnostics panel to view the
light path diagnostics LEDs and buttons. See "Operator information panel" on page 15, "Light path
diagnostics" on page 111, and "Light path diagnostics LEDs" on page 115 for more information about
light path diagnostics.
• Video connector: Connect a monitor to this connector. The video connectors on the front and rear of
the server can be used simultaneously.
Note: The maximum video resolution is 1600 x 1200 at 75 Hz.
• USB connectors: Connect a USB device, such as a USB mouse, keyboard, or other device, to any of
these connectors.

Operator information panel

The following illustrations show the location of the operator information panel and the LEDs on the operator
information panel respectively.
.
Chapter 1 The System x3530 M4 7160 server
15