Table of Contents
Advertisement
Step 5.
Disconnect the cables. Note the routing
1. Disconnect the signal cable from the connector on the system board.
2. Disconnect the power cable from the power supply or the power interposer card.
Step 6.
Pull the retention latch on top of the drive backplane cage and lift the backplate assembly up
slightly and pull it out; then, rotate it backward out of the tabs at the bottom of the drive cage and
remove the backplate assembly from the server.
Figure 173. Simple-swap SATA drive backplate assembly removal
Step 7.
If you are instructed to return the backplate assembly, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Replacing the simple-swap SATA drive backplate assembly
Use this information to replace the simple-swap drive SATA drive backplate assembly.
To install the replacement simple-swap SATA drive and backplate assembly, complete the following steps:
Note: The simple-swap SATA drive and backplate assembly must be installed in the backplane slot closest
to the information panel and the SATA drive must be installed in the drive-bay closest to the information
panel. The backplate assembly cable connects to the CD/DVD-ROM drive connector on the system board.
1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 31.
2. Align the tabs on the bottom of the drive backplate with the backplate slots on the bottom of the
backplane cage.
.
Chapter 6
Removing and replacing structural parts
261
Advertisement
Table of Contents
Troubleshooting
