Removing The Front Usb Connector Board - Lenovo x3530 M4 Installation And Service Manual

Note: You must wait approximately 1 to 3 minutes after you connect the server to a power source
before the power-control button becomes active.
Step 6. Start the Setup utility and reset the configuration.
• Set the system date and time.
• Set the power-on password.
• Reconfigure the server.
See "Using the Setup utility" on page 83 for details.

Removing the front USB connector board

Use this information to remove the front USB connector board.
To remove the front USB connector board, complete the following steps:
Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2. Turn off the server (see "Turning off the server" on page 22) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. Remove the server cover (see "Removing the server top cover" on page 188).
Step 4. Disconnect the USB cable from the connector on the rear of the USB assembly.
Step 5. (For 2.5-inch hard disk drive models) Press the release tab and push the USB assembly toward
the rear of the server.
Figure 159. Front USB connector board removal (for 2.5-inch HDD models)
Step 6. (For 3.5-inch hard disk drive models) Press the release tab and push the USB assembly toward
the front of the server.
250
Lenovo System x3530 M4 Installation and Service Guide