Table of Contents
Advertisement
Figure 55. Interposer card connection
Step 6.
Install the RAID adapter on the riser card and install the PCI riser-card assembly in the server (see
"Installing a PCI riser-card assembly" on page 45).
Step 7.
Connect the other end of the remote battery cable to the remote battery cable connector on the
battery carrier.
Attention: To avoid damage to the hardware, make sure that the black dot on the remote battery
cable connector faces away from the interposer card on the adapter. Do not force the remote
battery cable into the connector.
Step 8.
Route the remote battery cable in server as shown in the following illustration.
Attention: Make sure that the cable is not pinched and does not cover any connectors or obstruct
any components on the system board.
Step 9.
Install the battery on the safety cover:
a.
Orient the battery as shown in the following illustration; then, lower the battery onto the safety
cover. If the battery comes with a battery carrier, ensure that battery carrier posts align with
the rings on the battery mounting slot so that the battery carrier is secure in the slot.
Note: The positioning of the remote battery depends on the type of remote battery that you
install.
b.
Rotate the retention clip to the close position and press down on the retention clip until it
snaps in place to hold the battery in place.
Step 10. Connect the remote battery cable to the remote battery cable connector to the ServeRAID adapter.
Route the remote battery cable in the server as shown in the following illustration.
Attention: Make sure that the cable is not pinched and does not cover any connectors or obstruct
any components on the system board.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 73.
Installing an optional 4x2.5-inch hot-swap drive backplane
You can install a System x3530 M4 4x2.5-inch hot-swap drive backplane option in the server.
To install an optional 4x2.5-inch hot-swap drive backplane, complete the following steps:
.
Chapter 2
Installing optional devices
69
Advertisement
Table of Contents
Troubleshooting
