Lenovo x3530 M4 Installation And Service Manual page 159

Step 2. Remove the server cover. See "Removing the server top cover" on page 188 for more information.
Step 3. Locate the UEFI boot recovery jumper (J2) on the system board.
Figure 73. UEFI boot recovery jumper locations
Step 4. Move the jumper from pins 1 and 2 to pins 2 and 3 to enable the UEFI recovery mode.
Step 5. Reinstall the server cover; then, reconnect all power cords.
Step 6. Restart the server. The power-on self-test (POST) starts.
Step 7. Boot the server to an operating system that is supported by the IBM Flash UEFI Update package
that you downloaded.
Step 8. Perform the firmware update by following the instructions that are in the firmware update package
readme file.
Step 9. Copy the downloaded firmware update package into a directory.
Step 10. From a command line, type filename-s, where filename is the name of the executable file that you
downloaded with the firmware update package.
Step 11. Turn off the server and disconnect all power cords and external cables, and then remove the
server cover.
Step 12. Move the UEFI boot recovery jumper back to the primary position (pins 1 and 2).
Step 13. Reinstall the server cover, and then reconnect all the power cables.
Step 14. Restart the server.
In-band automated boot recovery method
Note: Use this method if the BOARD LED on the light path diagnostics panel is lit and there is a log entry
or Booting Backup Image is displayed on the firmware splash screen; otherwise, use the in-band manual
recovery method.
1. Boot the server to an operating system that is supported by the firmware update package that you
downloaded.
2. Perform the firmware update by following the instructions that are in the firmware update package
readme file.
3. Restart the server.
.
Chapter 4 Troubleshooting
145